Tape roll support

SKU: 56042
HAN: 66840
Category: Zubehör im Oberkopf
Manufacturers: Hunter Douglas

Tape reel bearing with turning cord for 80 mm slats, with emergency lowering and operating positions

Fully assembled
Adjustable slat position when raising using a plastic pin (item 66163 – please order separately if required)
Lifting tape attachment via pull cord holder (item 56016 – please order separately if required)
Suitable for 12 mm square shaft
Bearing with T-slot and 80 mm ball chain (95 mm length currently unavailable!)

If required:
80 mm ball chain also available separately under item number 66278-08

Lamellenbreite
Breite des Lagers
Zubehör

21,70 €

incl. 19% VAT , plus

From	Unit price
2	20,18 €*
10	18,45 €*
25	16,28 €*

Available immediately
Delivery status: Sofort versandfertig
Delivery time: 1 - 3 Workdays (DE - int. shipments may differ)

Description
Reviews

Tape reel bearing with turning cord for 80 mm slats, with emergency lowering and operating positions

Fully assembled
Adjustable slat position when raising using a plastic pin (item 66163 – please order separately if required)
Lifting tape attachment via pull cord holder (item 56016 – please order separately if required)
Suitable for 12 mm square shaft
Bearing with T-slot and 80 mm ball chain (95 mm length currently unavailable!)

If required:
80 mm ball chain also available separately under item number 66278-08

Information ball chain:

The basic function of the blind is always maintained provided that all installed swivel bearings have ball chains of equal length. However, this may result in a different closing behaviour. If 100% closure of the blind is not important to you, you can simply order a length of your choice.
If you want to ensure that the blind closes exactly as before, or if you only wish to replace some of the bearings, you must check the cord length in any case.

Measure the length of both ball-jointed hinges (front and rear) after removing the ramp stop. One hinge is always 80 mm long – the other is 80 or 95 mm.

Information Stop-Pin

Without pin = lowering and raising with slats closed (180° turn)
The pin limits the slat rotation during raising, so that depending on the position in which it is inserted, the slats remain in a horizontal position when raised! e.g. pin in 1st position: 90° turn